Patton-electronic 2173R Bedienungsanleitung

USER MANUALMODEL 2173RRuggedized High Speed Ethernet Extender SALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007Part# 07M12173R-UMRev. BRevise

10Figure 2. Model 2173R panel3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACEThe Model 2173R supports communication between two peer Ethernet LAN sites

11 2. The Model 2173R is equipped with either an RJ-45 interface jack that can be used on the CopperLINK interface. These CopperLINK inter-faces are

12Figure 4. Model 2173R 10/100Base-T RJ-45 Connector Pinout.3.3 CONNECTING POWERThe Model 2173R does not have a power switch, so it powers up as soon

13Figure 5. Removing protective coverFigure 6 on page 13 shows the orientation of the DIP switches in the On and Off positions.Figure 6. DIP switch or

144.2 CONFIGURING DIP SWITCH S1DIP switch S1 is where you configure the CopperLINK line. The following tables describe the configuration for the 2173

155.2 FRONT PANEL LED STATUS MONITORSThe Model 2173R features six front panel LEDs that monitor power, the Ethernet signals, the CopperLINK connectio

16APPENDIX ASPECIFICATIONSA.1 LAN CONNECTION• Two shielded RJ-45, 10/100Base-T, IEEE 802.3 Ethernet• CopperLINK Connection: Shielded RJ-45 A.2 TRANS

17APPENDIX BMODEL 2173R FACTORY REPLACEMENT PARTS AND ACCESSORIES*Only required with optional UI power supply (08055DCUI)Patton Model # DescriptionBas

18APPENDIX CMODEL 2173R INTERFACE PIN ASSIGNMENTC.1 10/100BASE-T INTERFACERJ-45• Pin 1: TX+• Pin 2: TX-• Pin 3: RX+• Pin 6: RX-• Pins 4, 5, 7, 8: no

19APPENDIX DSAMPLE RATES/DISTANCE CHART, BASED ON 24 AWG (0.5 MM)Note The actual distance and link performance may vary depending on the environment a

2CONTENTS1.0 Warranty Information ... 41.1 Compliance...

20Copyright © 2012Patton Electronics CompanyAll Rights Reserved.

3D Sample Rates/Distance Chart, Based on 24 AWG (0.5 MM) . 19

41.0 WARRANTY INFORMATIONPatton Electronics warrants all Model 2173R components to be free from defects, and will—at our option—repair or replace the

5reception. This equipment has been tested and found to comply with the limits for a Class A computing device in accordance with the specifica-tions i

61.6 SAFETY WHEN WORKING WITH ELECTRICITY• This device contains no user serviceable parts. This device can only be repaired by qualified service per

7In accordance with the requirements of council direc-tive 2002/96/EC on Waste of Electrical and Electronic Equipment (WEEE), ensure that at end-of-li

82.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is

9Figure 1. Typical applicationThe pair of 2173R and 2173 models work together to create a transparent extension between two peered Ethernet LANs. Figu