Patton-electronic 2190 Bedienungsanleitung

USERMANUALMODEL 2190V.90 Analog ModemPart# 07M2190-ADoc# 091011UARevised 01/29/99SALES OFFICE(301)975-1000TECHNICAL SUPPORT(301)975-1007http://www.pat

Fax Class 2 commands (continued)+FDIS: Report remote capabilities+FDIS= Current sessions parameters+FDR Begin or continue phase C receive data+FDT= Da

Commands to Change or Read Registers (continued)AT = ??? Changes the value of the last referenced register.??? = new valueAT? Displays the value of th

5.0 OPERATIONSOnce you have configured the Model 2190 properly. You are nowready to operate the unit. The following section describes the LED sta-tus

APPENDIX BPATTON ELECTRONICS MODEL 2190RESULT CODESSHORT FORM LONG FORM0OK1 Connect2 Ring3 No Carrier4 Error5 Connect 12006 No Dial Tone7 Busy8 No Ans

APPENDIX CPATTON ELECTRONICS MODEL 2190RS-232 (ITU-T V.24/V.28) PIN ASSIGNMENTSPINV.24 FUNCTIONS SIGNALS DIRECTION1 Frame Ground FG2 103 Transmitted D

12TABLE OF CONTENTSSection Page1.0 Warranty Information ...21.1 Radio and TV Interference1.2

1.3 FCC INFORMATIONThe Model 2190 has been tested and registered in compliancewith the specifications in Part 68 of the FCC rules. A label on theequi

3.0 INSTALLATIONThe Model 2190 is equipped with one RS-232 Serial Port, twoRJ-11 connectors, 2 jack hook-ups (1 microphone, 1 speakerphone), 1AC powe

4.2 AT COMMANDSRefer to the following AT Command Set Chart below. This chartidentifies the command function and describes the elements of thecommand.

AT Command Sets (continued) AT Command Sets (continued)TVnATV0ATV1Set Tone DialThis command forces DTMF dialing until the next P dial modifier or P co

AT Command Sets (continued)&Tn&V&V1&Wn&YnAT&T0AT&T1AT&T3AT&T4AT&T5AT&T6AT&T7AT&T8AT&W0AT&W

AT Command Sets (continued) 4.3 DIAL CODESThe following chart shows the Model 2190 dial codes and dialfunctions.Dial Codes\Nn\VnAT\N0AT\N1AT\N2AT\N3A

Dial Codes (continued)4.4 SUB PARAMETER DEFINITIONSThis section describes the Model 2190 sub parameters. Listedbelow are various modulations with the