Patton-electronic SmartNode 4830 Series Bedienungsanleitung PDF herunterladen (Seite 35)

Installing the VoIP IAD 35

SmartNode 4830 Getting Started Guide 3 • Hardware installation

Figure 14. Analog FXO connection

Installing the Ethernet cable

The SmartNode 4830 Series has automatic MDX (auto-cross-over) detection and conﬁguration on the Ether-

net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable

(see ﬁgure 15). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ethernet port(s)

(see table 6 for port pin-out listing) via a cable terminated with RJ-45 plugs.

Note Pins not listed are not used.

Table 6. Ethernet 10/100Base-T (RJ-45) port pin-outs

Pin Signal

1 TX+

2 TX-

3 RX+

6 RX-

RJ-11, male RJ-11, male

PSTN

wall plate

Ring (-) 3

Tip (+) 4

3 Ring (-)

4 Tip (+)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 88 89

Keine Kommentare

Patton-electronic SmartNode 4830 Series Bedienungsanleitung Seite 35